Electrolux IG1235SN Benutzerinformation Seite 15

Problem
The compressor does not
start immediately after
pressing the "FastFreeze",
or after changing the tem‐
perature.
Door is misaligned or inter‐
feres with ventilation grill.
Door does not open easily. You attempted to re-open
There is too much frost
and ice.
Water flows on the floor.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The FastFreeze function is
switched on.
The compressor starts af‐
ter a period of time.
The appliance is not level‐
led.
the door immediately after
closing.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
Appliance is fully loaded
and is set to the lowest
temperature.
Temperature set in the ap‐
pliance is too low and the
ambient temperature is too
high.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
The "FastFreeze function"
is switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
ENGLISH
Solution
Refer to "FastFreeze func‐
tion" section.
This is normal, no error
has occurred.
Refer to installation instruc‐
tions.
Wait a few seconds be‐
tween closing and re-open‐
ing of the door.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products
better.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Attach the melting water
outlet to the evaporative
tray.
Switch off "FastFreeze
function" manually, or wait
until the function deacti‐
vates automatically to set
the temperature. Refer to
"FastFreeze function" sec‐
tion.
Set a higher/lower temper‐
ature.
Refer to "Closing the door"
section.
15