BEARWARE 303715 Bedienungsanleitung Seite 21

Outdoor temperature display:
Low battery:
If the battery symbol appears next to the temperature display, then the inserted
batteries will soon be empty and should be replaced with new batteries as soon
as possible.
Channel display
The weather station receives the signal of the outdoor sensor automatically after
all settings have been configured. Press and hold the "Channel" button to clear
the currently displayed reading and to start rescanning for the outdoor sensor.
8. Basic settings
Note: By pressing the "SNOOZE/SLEEP" button, you can change between several
levels of brightness of the backlight. Please note that the base station does not
respond to 2 buttons at the same time. Therefore, it is advisable to always press
just one button.
To change from the day display to the second display, press the "MODE/SET"
button and then change the display using the "+" and "-" buttons. Press the
"MODE/SET" button again to select between the current outdoor temperature
and the dew point. Press the "MODE/SET" button once again to select between
the absolute (abs) and relative (rel) air pressure.
English
The outdoor temperature is measured by the
outdoor sensor and shown to an accuracy of one
tenth of a degree. The configured temperature
unit is displayed to the right of the reading. The
temperature unit can be changed between °C
and °F. To do this, press and hold the "MAX/
MIN" button on the weather station. This display
also shows the current air humidity experienced
by the weather station.
21