Safety Instructions; Electrical Connection - AEG RKE64021DW Benutzerinformation

16 www.aeg.com
•
•
•
•

2. SAFETY INSTRUCTIONS

2.1 Installation
• Remove all the packaging and the
• Do not install or use a damaged
• Follow the installation instructions
• Always take care when moving the
• Make sure the air can circulate around
• At first installation or after reversing
• Before carrying out any operations on
• Do not install the appliance close to
• Do not expose the appliance to the
• Do not install the appliance where
• Do not install this appliance in areas
• When you move the appliance, lift it
Downloaded from www.Manualslib.com
Do not use water spray and steam to clean the
appliance.
Clean the appliance with a moist soft cloth. Only use
neutral detergents. Do not use abrasive products,
abrasive cleaning pads, solvents or metal objects.
Do not store explosive substances such as aerosol
cans with a flammable propellant in this appliance.
If the supply cord is damaged, it must be replaced by
the manufacturer, its Authorised Service Centre or
similarly qualified persons in order to avoid a hazard.
WARNING!
Only a qualified person must
install this appliance.
transit bolts.
appliance.
supplied with the appliance.
appliance as it is heavy. Always use
safety gloves and enclosed footwear.
the appliance.
the door wait at least 4 hours before
connecting the appliance to the
power supply. This is to allow the oil
to flow back in the compressor.
the appliance (e.g. reversing the
door), remove the plug from the
power socket.
radiators or cookers, ovens or hobs.
rain.
there is direct sunlight.
that are too humid or too cold.
by the front edge to avoid scratching
the floor.
manuals search engine

2.2 Electrical connection

WARNING!
Risk of fire and electric
shock.
WARNING!
When positioning the
appliance, ensure the supply
cord is not trapped or
damaged.
WARNING!
Do not use multi-plug
adapters and extension
cables.
• The appliance must be earthed.
• Make sure that the parameters on the
rating plate are compatible with the
electrical ratings of the mains power
supply.
• Always use a correctly installed
shockproof socket.
• Make sure not to cause damage to
the electrical components (e.g. mains
plug, mains cable, compressor).
Contact the Authorised Service
Centre or an electrician to change the
electrical components.
• The mains cable must stay below the
level of the mains plug.
• Connect the mains plug to the mains
socket only at the end of the
installation. Make sure that there is
access to the mains plug after the
installation.