Werbung
Verfügbare Sprachen
Verfügbare Sprachen
REF.: SD103 | SD104 | STAR BRACE® DYNAMIC
English
INSTRUCTIONS FOR USE AND PRESERVATION
Dear customer,
Thank you for your trust in this Orliman product. You have acquired a quality product with a high
medicinal value. Please, read the instructions carefully. If you have any doubt, get in contact with
your doctor, your orthopaedist specialist or our customer service department. Orliman appreci-
ates your choice and wishes you a speedy recovery.
REGULATION
These products satisfy the European Medical Device Directive 93/42/CEE (RD. 1591/2009). A Risk
Analysis has been carried out (UNE EN ISO 14971) minimising all the existing risks. The trials have
been carried out in accordance with the European regulation UNE-EN ISO 22523 of Prosthesis and
Orthesis.
SUITABLE FOR
Ref.: SD100 STAR BRACE DYNAMIC SHORT SEMI-RIGID BACK SUPPORT.
Ref.: SD101 STAR BRACE DYNAMIC HIGH SEMI-RIGID BACK SUPPORT.
Recommended uses:
Lower back pain, lumbosciatic pain, degenerative processes, muscular debility and weakness,
pre- and post-surgery, disc hernias, spondyloarthrosis, strong sacrolumbar support, perfect ana-
tomical adjustment and comfort in day-to-day use.
Ref.: SD103 STAR BRACE DYNAMIC FIX SHORT RIGID CORSET.
Ref.: SD104 STAR BRACE DYNAMIC FIX HIGH RIGID CORSET.
Recommended uses:
Disc hernias. Osteoporosis. Spondyloarthrosis.
Spondylolysis with or without stability. Traumatisms.
Compression fractures. Degenerative disc disease.
Post-operation fusion. Chronic muscular disease.
Vertebral metastasis treatment.
FITTING INSTRUCTIONS
THE PRODUCT SHOULD BE ADJUSTED BY YOUR ORTHOPAEDIC TECHNICIAN OR IN ACCORDANCE
WITH DOCTOR'S ORDERS.
In order to obtain a greater degree of therapeutic effectiveness in the different pathologies and to
prolong the life and utility of the product, it is fundamental that the correct size adequate for each
patient or user is chosen (enclosed in the packet is a diagram with all the sizes and the equivalent
in centimetres). An excess compression can produce intolerance, therefore we recommend that
the compression be regulated to an optimum degree.
To fit observe the following aspects:
Adjusting and assembling the thermoplastic module and/or lumbar cushion:
⋅ (A-B) The Star Brace Dynamic corset is fitted with a thermoplastic lumbar cushion. Slide the cor-
set using the guide located on the lumbar plate for removal or positioning.
⋅ (C-D) The Star Brace Dynamic Fix corset is fitted with a thermoplastic lumbar module.
If the thermoplastic module needs adjusting:
⋅ Remove the lumbar cushion if fitted. If it is not fitted, remove the module by sliding along the
fabric cover guides.
⋅ Check the thermoplastic module on the patient and adjust and modify using the hot air gun. Then
assemble the thermoplastic module on the fabric cover by introducing the sacrolumbar corset
along the rear guides located between the thermoplastic module and the cover, ensuring it is as
aligned as possible, and fasten using the Velcro straps.
⋅ Coinciding with the abdominal zone of the corset lapel is a black elastic band which can be used
to secure the thermoplastic abdominal plate, protected by a padded fabric cover. Introduce this
strap in the groove fitted for this purpose in the thermoplastic piece, ensuring it is properly in
place.
⋅ Once all the components have been assembled, adjust it on the patient.
Adjusting the StarBrace Dynamics (SD100/101) to the patient:
Place the corset on the patient, ensuring the lumbar cushion is aligned, then fasten the corset and
adjust using the Velcro fasteners on the front.
Finally, adjust the required compression by tightening the left and right cord sections, which will
pull in the upper and lower parts of the orthosis, and secure using the colour-coded Velcro tabs.
Adjusting the StarBrace Dynamics Fix (SD103/104) to the patient:
Once the thermoplastic module fitted with the corset has been adjusted and/or modified, place the
corset on the patient, ensuring that the thermoplastic lumbar support is correctly positioned, then
wrap the fabric around the patient and adjust using the Velcro fasteners on the front, making sure
the abdominal thermoplastic plate is perfectly aligned.
Finally, adjust the required compression by tightening the left and right cord sections, which will
pull in the upper and lower parts of the orthosis, and secure using the colour-coded Velcro tabs.
PRECAUTIONS
The constructive material is inflammable.
Do not expose these products to situations where they could ignite. If this were the case remove
them quickly and use the necessary measures to put it out. The material used is hypoallergenic,
however we cannot guarantee 100% that in some determined cases it will not produce allergies, if
this occurs, remove the product and see the doctor that prescribed it.
In case of minor irritations due to sweat, we recommend the use of a cotton sock, to separate the
skin from contact with the material. For small inconvenience caused by sweat, we recommend us-
ing an interface to separate the skin from contact with the tissue. If rash, irritation or swelling to
remove the product and consult a doctor or prosthetist. Contraindicated in open scars with swell-
ing, redness and accumulation heat.
RECOMMENDATION-WARNINGS
These products are to be used only by those which have been medically prescribed to do so. Per-
sons unconnected to such prescriptions should not use them. When the product is not being used,
store in its original packaging. In order to dispose of the packaging and the product, strictly com-
ply with the legal norms of your community.
The use of the orthesis is conditioned to the recommendations of the prescribing doctor, therefore
it must not be used for any other means than those prescribed.
For the validity of the guarantee, the issuing establishment should comply with this sheet of in-
structions. Includes metal components so extreme caution to other uses, and in case of Magnetic
Resonance.
MANUFACTURE-CHARACTERISTICS
The material features used in production have been tested and approved and meet all the Euro-
pean quality requirements.
All the products are produced with high quality materials and offer an unbeatable comfort and
quality of use. All products offer restraint, stability and compression for the optimum treatment of
the pathologies for which they have been designed.
RECOMMENDATIONS FOR PRESERVATION AND CLEANING
Stick the velcros to each other (if the orthesis has any), wash periodically by hand with a damp
cloth and a neutral soap. To dry the orthesis, use a dry towel to absorb most of the dampness and
leave to dry at room temperature. Do not hang up or iron and do not expose to direct heat sources
such as stoves, heaters, radiators, direct sun light etc. During use or during washing do not use al-
cohols, ointments or dissolvent liquids. If the orthesis is not properly dried any detergent residues
could irritate the skin and deteriorate the product.
GUARANTEES
ORLIMAN, S.L.U. Guarantees all its products, as long as these have not been manipulated or al-
tered from their original state. Does not guarantee those products in which as a result of misuse,
deficiencies or breakage of any kind, its original state has been altered. If you observe any defi-
ciency or anomaly, communicate this immediately to the establishment from which it was obtained
in order for it to be changed.
ORLIMAN, S.L.U. Appreciates your choice and wishes you a speedy recovery.
Werbung
