Problem
The SmartGuard does not
move freely.
The SmartGuard does not re-
tract when the product is re-
moved away from the work
piece.
Transportation and storage
•
Safely attach the product during transportation to
prevent damage and accidents.
•
Remove the cutting blade before transportation or
storage of the product.
•
Keep the product in a locked area to prevent access
for children or persons that are not approved.
•
Keep the cutting blades in dry, frost free conditions.
•
Examine all new and used blades for transport and
storage damage before assembly.
•
Clean and maintain the product before storage.
Refer to
Maintenance schedule on page 25 .
Technical data
Cylinder displacement, cm
Cylinder bore, mm/in.
Travel length, mm/in.
Idle speed, rpm
Fully opened throttle, no load, rpm
Power, kW/hp @rpm
Spark plug
Electrode gap, mm/in.
Fuel tank capacity, liters/US fl oz
Recommended water pressure, bar/PSI
Weight
Power cutter without fuel and cutting blade 350mm (14in.), kg/Ib*
*Rescue carry strap, additional 0.4kg/0.9lb.
Power cutter without fuel and cutting blade 400mm (16in.) kg/Ib
32
Cause
The moving parts of the SmartGuard
are clogged.
The springs of the SmartGuard does
not operate correctly.
Transportation, storage and disposal
Technical data
3
/cu.in.
Possible solutions
Clean the moving parts.
Do a check of the springs. Clean the springs.
•
Remove the fuel from the fuel tank before long-term
storage.
Disposal
•
Obey the local recycling requirements and applicable
regulations.
•
Discard all chemicals, such as oil or fuel, at a service
center or at an applicable disposal location.
•
When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
K 970 III, K 970 III Res-
cue
93.6/5.7
56 /2.2
38/1.5
2700
9300 (+/- 150)
4.8 /6.5 @9000
NGK BPMR 7A
0.5/0.02
1/33.8
0.5-10/7-150
11.0/24.3
11.6/24.6
K 970 SmartGuard
93.6/5.7
56 /2.2
38/1.5
2700
9300 (+/- 150)
4.8 /6.5 @9000
NGK BPMR 7A
0.5/0.02
1/33.8
0.5-10/7-150
11.9/26.2
N/A
1429 - 001 - 16.04.2020