Transportation, Storage And Disposal - Husqvarna K 770 Dry Cut OilGuard Bedienungsanweisung

Problem
The blade guard extender and the
dust shield do not move freely.
The blade guard extender and the
dust shield do not move back when
the product is removed from the work
piece.
The fan does not operate.
Transportation and storage
• Safely attach the product during transportation to
prevent damage and accidents.
• Remove the cutting blade before transportation of
the product.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
• Keep the cutting blades in dry, frost free conditions.
• Examine new blades for storage damage.
• Remove the fuel from the fuel tank before long-term
storage.
• Get support from your local fuel vendor for
information where to discard the used fuel.
Disposal
• Obey the local recycling requirements and applicable
regulations.
• Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
• When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
861 - 004 - 27.02.2019
Cause
The moving parts of the blade guard
extender and the dust shield are
clogged.
The springs of the blade guard exten-
der and the dust shield do not opera-
te correctly.
The fan is blocked by foreign object.
The bearings are defective.
The fan belt does not have the cor-
rect tension.

Transportation, storage and disposal

Possible solutions
Clean the moving parts.
Do a check of the springs. Clean the
springs.
Remove the fan lid and remove the
foreign object that blocks the fan.
Do a check of the bearings.
Do a check of the fan belt.
135