Husqvarna K 970 III Bedienungsanweisung Seite 9

move back to their initial positions. This function locks
the throttle trigger at idle speed.
B
To do a check of the throttle trigger lockout
1. Make sure that the throttle trigger is locked at the
idle position when the throttle trigger lockout is
released.
2. Push the throttle trigger lockout and make sure that it
goes back when you release it.
1429 - 001 - 16.04.2020
3. Make sure that the throttle trigger and throttle trigger
A
4. Start the product and apply full throttle.
5. Release the throttle control and make sure that the
6. If the cutting blade rotates at idle position, adjust the
To do a check of the stop switch
1. Start the engine. Refer to
2. Push the stop switch to the STOP position. The
Blade guard and SmartGuard (Optional)
The blade guard (A) and SmartGuard (B) are installed
above the cutting blade (C). They prevent injury if pieces
lockout move freely and that the return springs
operate correctly.
cutting blade stops and stays stationary.
To adjust the idle speed on page
idle speed. Refer to
29 .
cold engine on page 22 .
engine must stop.
WARNING: Make sure that the blade guard
and SmartGuard are correctly attached
before you start the product. Do not use the
product if the blade guard or SmartGuard is
missing, defective or has cracks.
To start the product with a
9