SEH dongleserver Pro Schnellinstallationsanleitung Seite 7

WARNING
Do not operate all USB ports with maximum load!
The USB ports are grouped:
group 1 = 1, 2, 5, 6
group 2 = 3, 4, 7, 8
Each group can only be loaded with 1.2 A. If this value is
exceeded, USB ports will be deactivated until the load is
sufficiently reduced.
How to fix it:
If USB ports have been deactivated, you must decrease
the load on the UTN server to be able to use all USB
ports again. To do so, remove USB devices.
You must re-activate the USB port which has been
deactivated. All Information on how to do this can be
found in the dongleserver User Manual. The
documentation is available via the link on page 9.
Important:
If the network connection is interrupted for more that
13 minutes, the dongleserver Pro switches into standby
mode.
As soon as the network connection is re-established, the
dongleserver Pro switches back to normal operating
mode.
Quick Installation Guide [en] 5