Operation; Stand Alone Operation; Master/Slave-Operation - EuroLite TSL-100 Bedienungsanleitung

OPERATION

After you connected the effect to the mains, the TSL-100 LED Scan 20W starts running. During the Reset,
the motors are trimmed and the device is ready for use afterwards.
Turn the objective-lens for adjusting the focus in order to obtain a sharp projection.

Stand Alone operation

In the Stand Alone mode, the TSL-100 LED Scan 20W can be used without controller. You can do without a
controller as the TSL-100 LED Scan 20W features a built-in microphone, which provides automatic sound
control.
Disconnect the TSL-100 LED Scan 20W from the controller and select the desired "Master Mode".

Master/Slave-operation

The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the TSL-100 LED Scan 20W you can find an XLR-jack (DMX Out) and an XLR-plug
(DMX In), which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
Set the desired Master-mode for the master-device. Set the respective Slave-mode for all slave-devices.
Please refer to the instructions under Control Board.
23/28 00045979.DOC, Version 1.1