Replacing The Fuse; Technical Specifications - EuroLite TSL-100 Bedienungsanleitung

The lens has to be replaced when it is obviously damaged,
so that its function is impaired, e. g. due to cracks or deep scratches!
The objective lens will require weekly cleaning as smoke-fluid tends to building up residues, reducing the
light-output very quickly.
The interior of the fixture should be cleaned at least annually using a vacuum-cleaner or an air-jet.
There are no servicable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rearpanel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
DMX-control-channels:
DMX-512-connection:
Sound-control:
Flash-rate:
Color-wheel:
Static gobo-wheel:
Number of LEDs:
Dimensions (LxWxH):
Weight:
Maximum ambient temperature T a :
Maximum housing temperature T B (steady state):
Min.distance from flammable surfaces:
Min.distance to lighted object:
Fuse:
Accessory:
EUROLITE RC-1 remote control
DMX terminator DES-3 DMX 3-pin
Please note: Every information is subject to change without prior notice. 31.08.2009 ©
CAUTION!
230 V AC, 50 Hz ~
50 W
8
3-pin XLR
via built-in microphone
18 Hz
8 colors and open
8 gobos and open
1 x 20 W
390 x 205 x 300 mm
6 kg
45° C
55° C
0.5 m
0.1 m
F 2 A, 250 V
No. 51786121
No. 51834001
28/28 00045979.DOC, Version 1.1