Kemper kHS Montage- Und Bedienungsanleitung Seite 85

Status
Error
LED
Max. number of
switching cycles
exceeded.
20,000/50,000/
50,000
Thermal
disinfection limit
exceeded
Set-point max.
limit exceeded
Set-point min.
limit undercut
Frost protection
limit undercut
Set-point OK
Control in
standby
Flushing is
running
© www.kemper-olpe.de – 03.2020 / K410068602008-00 – 85 / 136
Description of warnings / notices
Possible cause
Warnings
The quarter turn stop valve
on the defective SLAVE has
performed more than 20,000
operating cycles.
The monitored temperature
has exceeded the set limit
value.
The monitored temperature
has exceeded the set limit
value.
The monitored temperature
has undercut the set limit
value.
The monitored temperature
has undercut the set limit
value.
Notes
Notice that the monitored
temperature is in the target
range.
No flushing pending. Control
in standby.
The valve on the involved
control is flushing / is open.
Measure
Replace the quarter
turn stop valve bon- The warning message
net in accordance cannot be confirmed.
with the maintenan- SLAVE continues to
ce manual and reset operate normally.
the operating cycles.
Check to see if it Entry in logbook and
needs to be set optional message via
otherwise.
Check to see if it Entry in logbook and
needs to be set optional message via
otherwise.
Check to see if it Entry in logbook and
needs to be set optional message via
otherwise.
Entry in logbook and
Prevent danger of
optional message via
valves freezing up.
Entry in logbook and
No action needed! optional message via
No action needed!
No action needed! Entry in logbook.
Effect
email.
email.
email.
email.
email.
No influence.