Cisco 300-Serie Kurzanleitung Seite 4

To connect the managed switch to the network:
S
TEP
S
TEP
S
TEP
N
OTE
connectivity. When you connect your network devices, do not exceed
the maximum cabling distance of 100 meters (328 feet). It can take up to
one minute for attached devices or the LAN to be operational after it is
connected. This is normal behavior.
Power over Ethernet (PoE) Considerations
If your switch is one of the PoE models, consider the following:
As a PSE (Power Sourcing Equipment) device, the switch can deliver a
maximum of 15.4 Watts per PoE port to a PD (Powered Device).
300 Series Managed Switches
Downloaded from www.Manualslib.com
Connecting Network Devices
2
Connect the Ethernet cable to the Ethernet port of a computer,
1
printer, network storage, or other network device.
Connect the other end of the network Ethernet cable to one of the
2
numbered managed switch Ethernet ports.
The LED of the port lights if the device connected is active. Refer to
Features of the Cisco Small Business Managed Switch, page 10
for details about the different ports and LEDs on each switch.
Repeat Step 1 and
3
the managed switch.
Cisco strongly recommends using Cat5 or better cable for Gigabit
manuals search engine
Step 2 for each device you want to connect to
4