Lcd Message Formats - TallyGenicom 3860 Schnellreferenzhandbuch

LCD MESSAGE FORMATS

40
Downloaded from www.Manualslib.com
The following are examples of the format of the LCD messages:
>active
The current selection on a multiple-choice menu is preceded by the
greater-than symbol (>).
Right: 8.500
When a number needs to be entered, the current setting is preceded by
a colon :
Right> 8.000
Then the arrow flashes after ENTER is pressed to save the change.
The following abbreviations are used in the LCD menu:
Auto Sw –
Auto switching. Both serial and parallel interfaces are selected.
Char Set -
Character Set. Select either of character sets 1or 2. Applies to ANSI and
Epson as well as to the two IBM emulations.
CPI -
Characters per Inch.
- Form Length.
Form Leng
- Interface. Choices are auto switching, serial, or parallel.
IntFace
- Lines per Inch.
LPI
- Message Language. The printer can present the LCD messages in English,
Msg Lang
Italian, German, Spanish and French.
PrFormat -
Print a Format report. This shows what is in each of the four stored formats.
PrintStat -
Print a Status sheet. This shows what is in the active format; in other words,
what the printer is set to do currently.
PrMenu -
Printed Menu. The printed menu has more configuration options than does
the LCD menu. See Chapter 4 of the 3860/80 User's Manual.
PrnRef -
Print Reference. Use to set a top offset and also a left offset to position
printing on the page. See Chapter 7 of the 3860/80 User's Manual.
Test Prn -
Test Print. This prints a rolling-ASCII pattern that reflects the current font,
margins, line and character spacing, etc.
Wire Impt –
Wire impact. Adjust impact of print head wires on ribbon. Level 4 is the
default. The higher the level number, the greater the impact. Use higher
levels for multi-part forms. Use lower levels for lightweight forms.
Setting the impact of the print head higher than is necessary
can cause unnecessary print head and ribbon wear.
manuals search engine
CAUTION:
GEK-01054