Installing The Front Tractor - TallyGenicom 3860 Schnellreferenzhandbuch

Installing the Front Tractor

At the front of the printer, pull the front
cover open and slide it into the storage
position.
Hook the notch on each side of the
tractor set over the mounting rod in the
front of the printer.
10
Downloaded from www.Manualslib.com
The Front or Bottom tractor is shipped uninstalled. Dual path machines
have the rear tractor already installed.
GEAR COVER (ENGAGED WITH MOUNTING PIN)
Install the paper motion detector wire into the connector on the right
side frame.
manuals search engine
MOUNTING PIN (BOTTOM FEED POSITION)
MOUNTING PIN (FRONT FEED POSITION)
NOTE:
MOUNTING
ROD
PAPER
MOTION
DETECTION
WIRE
CONNECTOR
GEK-01054