How To Load A Form - TallyGenicom 3860 Schnellreferenzhandbuch

How to load a form

22
Downloaded from www.Manualslib.com
Move the far tractor to tighten the paper.
Stretch the paper enough so it does not sag, but not so tightly as to
distort the pin-feed holes.
Lock the far tractor.
Push the locking lever toward the printer to secure the tractor.
Check the paper.
There must not be any tears or wrinkles. Make sure the paper is loaded
straight.
Close the home-position tractor door.
Close the Top Cover
If the LCD says
LOCKED
Path >Rear
Fault: Paper Out
ADJUSTING GAP
Make sure paper feeds without difficulty
Press the FF/Load key once. Paper will feed out of the printer.
manuals search engine
See "Control Panel Lockouts", Chapter 5, in the 3860/80
User's Manual. Otherwise,
Press and release PARK/PATH until the LCD says Path
Rear.
The rear paper path is now selected. Wait a few
seconds for the function to time out.
The paper path selection function has timed out. The
printer is now ready to load a form.
Press the FF/Load key.
Paper should move into position to be printed. The Fault
light will go out. On dual paper path machines, the print
gap will be adjusted for the form that was just loaded.
On single paper path machines, you will need to adjust
the print gap manually.
GEK-01054