Align The Printer; Required Tools - Rimage Producer serie Benutzerhandbuch

Rimage Producer III™ and Producer IIIN™ User Guide

Align the Printer

This section provides instructions to align the Everest or Prism printer to your autoloader.

Required tools:

•
T25 Torx screwdriver
•
5/32" Allen wrench
1. Power on the autoloader. Refer to Power on the Producer III Autoloader on page 9.
2. Wait for the autoloader to complete initialization.
Tip: The autoloader takes one to two minutes to complete initialization.
3. Open the front door of the autoloader.
4. Prepare the unit for alignment.
a. Manually move the lift arm to the top of the column.
b. Press one disc up into the lift arm while pressing the
disc release button.
c. Press the printer button. The printer tray opens.
5. Open the top access cover.
Tip: Look down through the top opening to observe
printer alignment.
16
Downloaded from www.Manualslib.com manuals search engine
Gripper
Disc Release Button
Top Access Cover
Lift
Arm
2000538_B