Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Rimage Producer III™ and Producer IIIN™ User Guide
Parts Information
Status Light
The Producer III can be equipped with an optional status light that indicates various conditions. This table shows
status light states and explains the conditions indicated by each state.
Light state
Green
light on
Green
light
blinking
Yellow
light on
Yellow
light
blinking
Red light
on
Operator Panel
The operator panel has a two-line display that informs you of operations or conditions that require operator
intervention. This includes the consumable status. After initialization, the Producer IIIN displays the name of the
embedded PC. Refer to the Gemini Utilities section on page 18 to see other options.
Note: The caret symbol '^' in the upper right corner of the display indicates that the Rimage software is currently
communicating with the autoloader.
Operator Button
To access the operator button, open the front door. Press the operator button to rotate the carousel and position a bin
so that discs can be loaded or unloaded. Each time you press the operator button, the carousel rotates to the next
bin.
Tip: The carousel will rotate to a bin only after the autoloader has completed initializing.
Disc Dispenser
Only the 8100 and 8100N have the disc dispenser.
Beeper
The Producer III autoloader has a beeper that sounds when user intervention is required. Read the condition on the
operator panel or at the client application and take appropriate action to correct the problem.
8
Downloaded from
www.Manualslib.com
System condition
The system is operating properly. No jobs are currently processing.
The system is operating properly. Jobs are currently processing.
The autoloader is waiting for the software to start. If the Control Center is not started,
switch on the Control Center. Check the cable connections on the autoloader and Control
Center.
The front door may be open. Close the front door to allow jobs to process.
Print ribbon or media may be running low. Read the operator panel to determine which
supply is running low.
Out of blank discs. Fill the supply bins with the appropriate media type.
System error requiring operator intervention. Check the client workstation or Control Center
for a message.
Equipment error at initial start up, such as a missing carousel. Check the client workstation
or Control Center for a message.
manuals search engine
2000538_B
Werbung
Kapitel
