Handling A Staple Jam - Kyocera DF-73 Bedienungsanleitung

6. Reinstall the staple holder in its original
location inside the staple unit. The staple
holder will click into place when it is
properly inserted.

Handling a staple jam

If a paper jam happens to occur during
stapling, a staple may have jammed. In this
case, perform the following procedure.
3. Push the face plate closed into its original
position.
Downloaded from www.Manualslib.com
7. Close the stapler cover.
1. Remove the staple holder using the same
procedure as in "Replenishing staples".
Then, open the face plate by pushing on
the tab (B) with your finger.
4. Reinstall the staple holder in its original
location inside the staple unit. The staple
holder will click into place when it is
properly inserted.
manuals search engine
(B)
2. Remove any jammed staples from the
front of the staple holder (where the
staples are set).
5. Close the stapler cover.
9