Verwandte Anleitungen für Kyocera DF-7120
Inhaltszusammenfassung für Kyocera DF-7120
- Seite 1 DF-7120 INSTALLATION GUIDE GUIDE D’INSTALLATION GUÍA DE INSTALACION INSTALLATIONSANLEITUNG GUIDA ALL’INSTALLAZIONE...
- Seite 2 Color MFP Color Printer Black & White MFP 25/25ppm,32/32ppm, 60/55ppm 30ppm,32ppm, 35/35ppm,40/40ppm, 35ppm,40ppm 50/50ppm,60/55ppm Black & White Printer Black & White MFP 60ppm 40ppm,50ppm,60ppm (EN) A different procedure is required depending on the product which is installed with this unit.Each procedure is described in the following pages. For installation with the MFP(A) / Printer, see Page 1 to Page 5,Page 14 to Page 15.
- Seite 3 F(M4x20) F(M4x20) C(M4x8) C(M4x8) AK-7100 AK-7100 Be sure to remove any tape and/or cushioning materials from the parts supplied. Be sure to remove any tape and/or cushioning materials from the parts supplied. (EN) Veillez à retirer les morceaux de bande adhésive et/ou les matériaux de rembourrage des pièces fournies.
- Seite 4 C(M4x8) C(M4x8)
- Seite 6 c = d c = d c ＞ d , c ＜ d c ＞ d , c ＜ d c ＞ d c ＞ d c ＜ d c ＜ d...
- Seite 8 C(M4x8) F(M4x20) F(M4x20) C(M4x8) AK-740 AK-740 Be sure to remove any tape and/or cushioning materials from the parts supplied. (EN) Be sure to remove any tape and/or cushioning materials from the parts supplied. (FR) Veillez à retirer les morceaux de bande adhésive et/ou les matériaux de Veillez à...
- Seite 10 PF-810 PF-791 AK-7100 C(M4x8) C(M4x8) C(M4x8) PF-810 PF-791 F(M4x20) F(M4x20) F(M4x20) PF-810...
- Seite 13 c = d c ＞ d , c ＜ d...
- Seite 14 c ＞ d c ＜ d...
- Seite 16 78.5mm±2.5mm (157mm) (EN) Adjusting the stapling position 1.Connect the machine power plug to the wall outlet and turn the machine main power switch on. 2.Make a test copy using staple mode (double stapled). 3.Check whether the stapling position is off-center.If the staple position is off-center, follow the procedure below to adjust the position. <Reference value>...
- Seite 17 4.Set the maintenance mode U246 and select [Finisher] > [Staple HP]. 6.Press the [Start] key to confirm the setting value. 5.Adjust the values. 7.Perform a test copy. If the paper is stapled too close to the front of the machine (a): Increase 8.Repeat steps 4 to 7 until the staple position is within the reference the setting value.
- Seite 18 MEMO...
- Seite 20 2019.9 303RV5671005...