Herunterladen Inhalt Inhalt Diese Seite drucken

Adding Dishwasher Salt - hanseatic WQP12-7735T Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Dishwasher detergents, rinse aids and dishwasher salts
Changing rinse aid setting
We would recommend that you do not change
the dosage that was set by the factory initially.
If the dishes are
– matt and stained after cleaning, increase
the dose.
– sticky and streaky, you should decrease
the dose.
Quickly take the following steps, otherwise
interrupt the process from (see 'Adjusting the
water hardness' on page EN-34).
1. Switch on the appliance with the
button (1).
2. Press and hold the
onds within 60 seconds of switching on
the appliance.
3. Press the
button (3) to enter the set-
tings mode.
The indicator
(17) will flash. The current
value (d1 to d5) illuminates on the display (5).
4. Select the desired dose using the
button (9): from d1 (low) to d5 (high).
5. The appliance will save the setting
after 5 seconds, and the display will re-
turn to the original indicator.

Adding dishwasher salt

NOTICE
Risk of damage!
You may damage the dishwasher, its
stainless steel surface, its seals and fi l-
ters by using dishwasher salt in an im-
proper manner.
Only use regenerating salt which is
suitable for dishwashers.
Always wipe away split dishwasher
salt immediately with a damp cloth.
Immediately after adding the dish-
washer salt, launch a dishwashing
programme.
(9) button for 5 sec-
You do not need to add dishwasher
salt to the dishwasher salt dispenser
– if you are only using multitabs which al-
ready contain dishwasher salt,
– if the water hardness in your area is in the
0–5° dH range.
Add dishwasher salt:
– prior to using the dishwasher for the first
time,
– when the 'Add dishwasher salt' indicator (18)
lights up.
(33)
1. Remove the lower dish rack (29).
2. Turn the cover of the dishwasher salt con-
tainer (33) in an anti-clockwise direction
and remove it.
3. Upon first use: Add 1.5 l water to the dish-
washer salt compartment so that the dish-
washer salt does not clump.
(b)
4. Place the supplied filling funnel (b) on the
dispenser opening.
5. Add dishwasher salt up to the edge of the
compartment. Water may come out; this
is not a problem.
6. Stir the dishwasher salt using the end of a
spoon or similar.
Page EN-13

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Wqp12-7735t decoframe

Inhaltsverzeichnis