Saeco Magic espresso Bedienungsanleitung Seite 28

ENGLISH
Problem
The machine does not turn on
The pump is very noisy
The coffee is too cold
The milk does not froth properly
The coffee flows out too fast and no
creamy froth forms on the surface
No coffee flows out or it just drips
out slowly
Coffee leaks outside the rim
Should any problems occur that are not included in the above table or cannot be
resolved using the remedies suggested contact an authorised service centre.
• 28 •
Downloaded from www.Manualslib.com
Possible causes
The machine is not connected to the
power supply
Water level in tank too low
The temperature ready light (5) was off
when you pressed the switch (4)
Filter holder not inserted for pre-
heating (section 5).
Wrong kind of milk
Not enough coffee in the filter holder Add some coffee (section 5)
Coffee ground too coarsely
Stale or unsuitable coffee.
Water level in tank too low
Coffee ground too finely
Coffee compressed too firmly in the
filter
Too much coffee in the filter
"Hot water/steam" knob (7) open.
Excessive buildup of scale
Filter in filter holder clogged
Filter holder not properly fit into brew
unit
Upper rim of filter holder dirty
Boiler gasket dirty or worn
Too much coffee in the filter holder
manuals search engine
Troubleshooting
Remedy
Connect the machine to the
power supply
Add water
(section 4.4)
Wait until the light goes on
Pre-heat the filter holder
Check the fat content
Use a different blend
(section 6)
Use a different blend
(section 6).
Add water
(section 4.4)
Use a different blend
(section 6)
Loosen the ground coffee
Reduce the amount of
coffee in the filter holder
Turn the knob (7) clockwise
to close
Descale the machine
(section 10)
Clean the filter (section 9)
Fit the filter holder properly
in place (section 5)
Clean the filter holder rim
Clean or replace gasket
Reduce the amount of
coffee.
Use the measure for the
right amount.