Important Notes; Use As Directed; Disposal Of Old Unit; Code Theft Protection - Bosch Dover USB40 Bedienungs- Und Einbauanleitung

30 | en

Important notes

Read these instructions carefully and familiar-
ize yourself with the device before starting
operation of your device. Keep these instruc-
tions in the vehicle in case of subsequent
questions.

Use as directed

The device has been designed to operate in a
commercial vehicle with a 12 V vehicle power
supply (7 620 000 120 / 122) or a 24 V
vehicle power supply (7 620 000 121 / 123),
and to be fitted into a 1-DIN slot.
Road safety
Road safety has absolute priority.
Only operate your device if the road
and traffic conditions allow you to do
so. Familiarize yourself with the
device before setting off on your
journey.
You should always be able to hear
police, fire and ambulance sirens in
good time from inside your vehicle.
For this reason, listen to your car
sound system at a reasonable volume
level during your journey.

Disposal of old unit

Do not dispose of your old device in
the household trash!
Use the return and collection systems
available to dispose of the old device.
7 620 000 120 - 123 | 10.2010
Important notes | CODE theft protection

CODE theft protection

Your device is equipped with a four-digit code
number for protection against theft. This
number must always be entered whenever the
device has been separated from the operating
voltage of the vehicle. The code query is active
by default, but it can be switched off.
Note:
If the code query is activated, the
Code LED = starts flashing if both
the device and the vehicle ignition are
switched off.
The code number is located in the
radio pass for your device.
Note:
Never keep the radio pass inside the
vehicle!
Switching code query on/off
(CODE)
f Press the MENU 5 button to open the
menu.
f Press the MENU 5 button repeatedly
until "CODE" appears in the display.
After about 2 seconds, "0000" appears on the
display, and you can enter the code:
Note:
If you enter an incorrect code
number, "ERROR" appears on the
display, after which "0000" is shown
again. You can make the entry two
more times. After the third incorrect
entry, the device is locked for 1 hour.
During this time, the display shows
Robert Bosch Car Multimedia GmbH