Entering The Code Number After A Voltage Interruption - Bosch Dover USB40 Bedienungs- Und Einbauanleitung

CODE theft protection
"WAIT 1 HOUR". If you switch off the
device during this waiting period, you
will have to wait again for a full hour
after switching it on again.
f Press the station button 1 : repeatedly
until the first digit from your code number
appears on the display.
f Press the station button 2 : repeatedly
until the second digit from your code
number appears on the display.
f Press the station button 3 : repeatedly
until the third digit from your code number
appears on the display.
f Press the station button 4 : repeatedly
until the fourth digit from your code
number appears on the display.
Note:
As soon as you have selected a
position from the code number by
pressing the station button 1 - 4 : it
is also possible to set the code
number digits using the volume
control 1.
When the correct code number is shown on the
display,
f Hold down the station button 5 : for
longer than 2 seconds.
The display again shows "CODE" and the
current setting "ON" or "OFF".
f Turn the volume controller 1 to the left
or right in order to switch code query on
or off.
Robert Bosch Car Multimedia GmbH
In order to leave the menu
f Press the MENU 5 button, repeatedly if
necessary.
Entering the code number after a
voltage interruption
f Switch on the device.
The display first shows "CODE" and then
"0000". You can enter the code:
Note:
If you enter an incorrect code
number, "ERROR" appears on the
display, after which "0000" is shown
again. You can make the entry two
more times. After the third incorrect
entry, the device is locked for 1 hour.
During this time, the display shows
"BLOCKED". If you switch off the
device during this waiting period, you
will have to wait again for a full hour
after switching it on again.
f Enter the code number as described in the
section "Switching code query on/off".
f When the correct code number is shown
on the display, hold down the station
button 5 : for longer than 2 seconds.
The device will be switched on. "TIMESET" will
appear for about 2 seconds on the display,
after which the menu for entering the time will
open.
f Enter the time as described in the "Setting
the time" section of the "Time" chapter.
f Confirm the time you have entered by
pressing the SRC < key.
7 620 000 120 - 123 | 10.2010
en | 31