V-Sync; Color/Bw - Samsung SCC-C6405P Benutzerhandbuch

(CAMERA SET)
CAMERA ID ON...

V-SYNC

INT

COLOR/BW

COLOR
MOTION DET OFF Press
ZOOM SPEED 3
[Enter]
DIGITAL ZOOM OFF
EXIT QUIT
* " ... " Means there are Sub Menus.
V-SYNC
In the V-SYNC menu, vertical synchronization can be selected. The
vertical synchronization signal supported by the SCC-C6405(P) is the INT
mode made by clock inside the SCC-C6405(P) and LINE mode adjusting
vertical synchronization to the exterior power frequency.
Select LINE and press [Enter]. You will see the LINE LOCK submenu
where you can adjust the phase of the LINE LOCK.
You can use the PHASE menu of the LINE LOCK submenu to assign as
much PHASE as you want.
(CAMERA SET)
CAMERA ID OFF
V-SYNC LINE...
COLOR/BW COLOR
MOTION DET OFF
ZOOM SPEED 3
DIGITAL ZOOM OFF
EXIT QUIT
3-5
(CAMERA ID)
A B C D E F G H I J K L
➜
M N O PQ R S T U V W X
Y Z 0 1 2 3 4 5 6 7 8 9
: ! - + ✽ ( ) /
SP ï î SP
LOCATION...
RET
SCC-C6405P........
(LL-PHASE)
➜
Press
[Enter]
PHASE (000)----
RET
COLOR/BW
In the COLOR/BW menu, you can switch ON or OFF the IR (infrared) Filter.
In a poor illumination environment, the IR filter is turned off in the BW mode the its
sensitivity increases as high as a black and white camera. On the other hand, the
IR filter is turned on and the sensitivity decreases in the COLOR mode.
COLOR
BW
AUTO
- BURST ON : The color burst signal is output together with black and white
- BURST OFF : The color burst signal is not output.
- LEVEL
- DURATION : Set the HOLDING time for switching between COLOR and BW
----
I
In AUTO mode, AGC will operates in high speed mode, and you cannot
change it manually, as it is indicated by "---".
(CAMERA SET)
CAMERA ID
V-SYNC
COLOR/BW
MOTION DET
ZOOM SPEED
DIGITAL ZOOM
EXIT
Caution : If you use an infrared light source while in AUTO mode, AUTO
: The IR Filter is ON and the screen is normal.
: The IR Filter is OFF and the screen is black and white.
(Sensitivity to low light is increased to a level comparable to a black
and white camera.)
Select BW and press [ENTER] and the additional menu to select
BURST ON/OFF will appear.
: Select to automatically switch between the COLOR mode and BW
mode depending on the amount of light. In low light conditions, the
IR Filter is turned OFF and the sensitivity to low light is increased
by switching to the BW mode, but in bright light conditions, the IR
Filter is turned ON and the sensitivity is decreased by switching to
the COLOR mode.
Select AUTO and press [ENTER] and the additional menu to select
BW LEVEL and DURATION will appear.
composite video signal.
: You can set the brightness level that changes from COLOR mode
to BW mode in 3 steps : LOW, MEDIUM, and HIGH.
mode depending the changes in the amount of light. You can set
the HOLDING time to 10sec (S), 30sec, 60sec, or 300sec( L).
➜
OFF
INT
AUTO...
Press
OFF
[Enter]
0
0
QUIT
switching malfunction and camera AF malfunction may occur.
E
(AUTO)
BURST ON
LEVEL LOW
DURATION S --|---- L
RET
3-6