Turbo P/T; Auto Cal; D-Flip; Cam Reset - Samsung SCC-C6405P Benutzerhandbuch

TURBO P/T

This function doubles up the speed of PAN/TILT movement by manual
operation of PAN/TILT. The speed may go up to 180°/sec(PAN).

AUTO CAL

This function turns on or off Auto Calibration. SCC-C6405(P) has the Auto
Calibration function to improve the precision of LENS and PAN/TILT
motor. You may set to OFF/6H/12H/18H/24H. Without user's key input for
the time designated by the user, A.C. will appear on the screen while
initializing LENS and PAN/TILT.

D-FLIP

When D-FLIP is off, TILT movement ranges from 0° to 90°.
When D-FLIP is on, TILT movement ranges from 0° to 180°.
When D-FLIP is on, images mirror vertically and horizontally in the area
beyond TILT 90°.

CAM RESET

CAM RESET clears all the settings made so far and restores the factory
default settings.
"CAMERA RESET?" message appears when you select CAM RESET.
Select "CANCEL" to return to the menu setup display or select OK to
restore the factory default settings.
❈ Be careful when performing a CAM RESET operation, as it deletes all
setup values.

LANGUAGE

This function selects a language for MENU setup. Press UP/DOWN key to
choose English, French, German, Spanish, or Italian, and the selected
language will be applied to the full screen.

PASSWORD

This function selects or cancels the MENU setup password. Press
[ENTER] at the state of PASSWORD ON, and the following screen will
appear for password setup.
3-29
(OTHER SET)
PROPORTIONAL P/T ON
TURBO P/T OFF ➜
AUTO CAL. OFF
D-FLIP ON
CAM RESET ... Press
LANGUAGE ENGLISH
[Enter]
PASSWORD ON...
EXIT QUIT
Press UP/DOWN/LEFT/RIGHT key to locate the cursor on a number and
press [ENTER] for password setup. After you finish inputting the 4 digits
password and the 2nd row of the 4 digits PASSWORD input screen, input
the selected password again for reassurance.
If correct, the cursor will move to RET.
Press [ENTER] at RET, and the selected password will be saved,
returning to the OTHER SET screen.
Default password is 0123.

8. SYSTEM INFO

This menu allows you to check S/W version, communication protocol,
baud rate, and address of SCC-C6405(P).
* * MAIN MENU * *
CAMERA SET...
VIDEO SET...
PRESET...
ZONE SET...
AUTO SET...
[Enter]
ALARM SET...
OTHER SET...
SYSTEM INFO...
(PASSWORD)
0 1 2 3 4
5 6 7 8 9
✽ ✽ ✽ ✽
✽ ✽ ✽ ✽
RET
( SYSTEM INFO)
FPGA VER. V1.000
ALARM VER. V1.000
➜
MOTOR VER. V1.000
CAMERA VER. V1.000
EEPROM VER. V1.000
Press
PROTOCOL SAMSUNG
COMM. TYPE RS-485, HALF
BAUD RATE 38400
ADDRESS 0
RET
E
3-30