Camera Id; V-Sync - Samsung SCC-C6475 Benutzerhandbuch

❈
If the power is turned off after PRESET, AUTO PAN, SCAN,
PATTERN function is activated and no other control is made, camera
will do the same function after the power is turned on.
❈
Menu setting is available only when tilt position is under 90°.
When tilt position is over 90° and menu-on command is received,
pan will automatically rotate 180° and tilt will be move to the
corresponding position.
Use the controller to press the MENU selection key and the following
screen will be displayed.
* * MAIN MENU * *
CAMERA SET...
VIDEO SET...
PRESET ...
ZONE SET...
AUTO SET...
ALARM SET...
OTHER SET...
SYSTEM INFO...
➀
PASSWORD
UNDEFINED
➀
In case of , use UP/DOWN/LEFT/RIGHT/[ENTER] key for MENU
➁
setup. In case of , type in the 4 digit password first. If correct, the
➀
MENU selection screen like
set up MENU by pressing UP/DOWN/LEFT/RIGHT/[ENTER] key.
1. CAMERA SET MENU

CAMERA ID

The CAMERA ID menu assigns an ID to the SCC-C6475(P) to be displayed
on the connected monitor.On the CAMERA SET menu screen, select
CAMERA ID to ON and press [Enter]. You will see the sub screen for
deciding on the ID of the SCC-C6475(P). The Camera ID can have up to
20 alphanumeric characters, along with several special characters.
The assigned camera ID may be positioned to any desired location on the
screen by using the LOCATION submenu.
C C a a u u t t i i o o n n
C C a a u u t t i i o o n n
CAMERA ID OSD is not displayed in the network viewer.
4-4
0 1 2 3 4
5 6 7 8 9
✽ ✽ ✽ ✽
➁
PASSWORD
DEFINED
will be displayed and you will be able to
(CAMERA SET)
➜
CAMERA ID ON...

V-SYNC

INT
COLOR/BW COLOR
MOTION DET OFF Press
ZOOM SPEED 3
[Enter]
DIGITAL ZOOM OFF
EXIT QUIT
* " ... " Means there are Sub Menus.
V-SYNC
In the V-SYNC menu, vertical synchronization can be selected. The
vertical synchronization signal supported by the SCC-C6475(P) is the INT
mode made by clock inside the SCC-C6475(P) and LINE mode adjusting
vertical synchronization to the exterior power frequency.
Select LINE and press [Enter]. You will see the LINE LOCK submenu
where you can adjust the phase of the LINE LOCK.
You can use the PHASE menu of the LINE LOCK submenu to assign as
much PHASE as you want.
(CAMERA SET)
➜
CAMERA ID OFF
V-SYNC LINE...
COLOR/BW COLOR
Press
MOTION DET OFF
[Enter]
ZOOM SPEED 3
DIGITAL ZOOM OFF
EXIT QUIT
(CAMERA ID)
A B C D E F G H I J K L
M N O PQ R S T U V W X
Y Z 0 1 2 3 4 5 6 7 8 9
: ! - + ✽ ( ) /
SP ï î SP
LOCATION...
RET
SCC-C6475(P)........
(LL-PHASE)
PHASE (000)---- ----
I
RET
4-5
E