Television Operation - Clatronic TV 486 Bedienungsanleitung

5....-05-TV 486 DK
• Insert the mains adapter into a correctly installed 230 V, 50 Hertz safety socket.
GB
NOTE: After use, always remove the mains adapter from the socket, as it uses
small quantities of electricity even when the television set is switched off. You should
only use the enclosed mains adapter or one with the same technical values, as
otherwise the electronics of the equipment may be damaged.
Operation with a Car Cigarette Lighter
• Insert the plug of the enclosed car adapter (cigarette lighter adapter) into the
DC-12 V-IN socket (on the back) of the television set.
• Insert the car adapter into the cigarette lighter of your car.
Operation with Batteries
• Open the battery compartment on the bottom of the television set.
• Insert 10 x 1.5 V batteries of type UM-2 as depicted on the bottom of the battery
compartment. Ensure the correct polarity! If the batteries are inserted the wrong
way round, this may destroy the equipment!
• Close the battery compartment.
NOTE: If you do not use the machine for a prolonged period, or operate it using a
mains adapter, the batteries should be removed in order to prevent battery acid
from leaking!
1. Push the TV/OFF/RADIO switch (located on the right-hand side of the television
set) to the TV position.
2. Pull out the telescopic aerial as far as it will go and turn it until you receive the
best possible reception.
3. Push the FM-VHF-LOW/HIGH/AM-UHF switch to the desired band range:
LOW = VHF L band 1, HIGH = VHF H band 3 or UHF = band 4+5.
4. Use the TUNING control located on the right-hand side of the television set to
tune in to the desired station.
5. The scale above the screen shows the station to which the television is currently
tuned.
NOTE: The reception may be impaired through poor reception locations or thick
building insulation, etc! Try to optimise reception by turning the aerial. If necessary,
move the television set to another position.
You can adjust the volume to your requirements with the VOLUME regulator on the
right-hand side of the television set.
Picture Adjustment
You can adjust the picture to your requirements with the BRIGHT (brightness) and
CONT (contrast) controls. If the picture rolls up or down, turn the vertical hold (V-
HOLD) until the picture comes to a standstill.
16
16.10.2002 8:36 Uhr

Television Operation

Seite 16