Installation; Installing The Imprinter - Fujitsu fi-412PR Bedienungshandbuch

2. Installation

2.1. Installing the Imprinter

Install the imprinter as follows:
1. Press the
disconnect the electrical power cable.
2. Remove the Stacker from the scanner as shown
below.
1) Hold the left side of the stacker with left hand.
2) While pressing on the scanner with your thumb, pull the
3) When the left side of the stacker has been released from
ATTENTION
Downloaded from www.Manualslib.com
button to switch off the Scanner and
About 80 degrees
stacker gently away from the scanner.
2
Carefully pull the stacker
out.
1 Press your thumb on the scanner.
the scanner, remove the right side of the stacker.
You must remove the stacker before installing
the scanner to the imprinter.
manuals search engine
3.
4.
Hold the Scanner above the rear side of the Imprinter and
gently place the Scanner on to the base of the Imprinter
while lowering it forward until it makes contact with the
Stacker
Imprinter.
ATTENTION
After installation
Remove the two screws located at the back of the
scanner.
Install the Scanner on to the Imprinter.
● Be careful not to place the Scanner on to
the Fix Tabs or hit hard against them as
you might damage the Fix Tabs.
● Take care not to pinch your fingers.
fi-412PR Imprinter Operator's Guide | 5
Fix Tab