Measurements; Adjusted Mode Measurement - A&D UT-201BLE-A Bedienungsanleitung Übersetzung

Adjusted Mode Measurement

1. Press the
When the last measurement is stored,
it is displayed for approximately two
seconds.
2. Wait until " " is displayed.
3. Put the temperature sensor on the
mouth floor (under the tongue, at the
root of the tongue and at the side of
the lingual frenulum).
Close the mouth gently.
4. keep the sensor position during
measurement for approximately
30 seconds.
5. The count down indicator is
displayed.
The adjusted mode measurement
mark blinks and rotates.
6. The result is displayed for
approximately 15 seconds, the
adjusted mode measurement mark
lights, the LED of the
blinks and buzzer sounds when the
adjusted mode measurement finishes.
7. Select an operation.
Press the
Keep the sensor position to use the direct mode
measurement. Proceed to next page.

Measurements

switch.
switch
switch to turn the thermometer off.
English 13
Turn on the device.
Last data
Ready
Sensor position
Measurement start
Count down indicator
Adjisted mode
measurement mark
The result
Mark lights
To next page if the direct
mode measurement is used.