Wireless Function - A&D UT-201BLE-A Bedienungsanleitung Übersetzung

Using the Thermometer

Wireless Function

Caution
In the unlikely event that this thermometer causes radio wave
interference to a different wireless station, change the location where this
thermometer is used or stop use immediately.
Be sure to use in a location where visibility between the two devices that
you want to connect is good. The connection distance is reduced by the
structure of buildings or other obstructions. In particular, connection may
be impossible when devices are used on either side of reinforced
concrete.
Do not use Bluetooth
other wireless devices, near devices that emit radio waves such as
microwaves, in locations where there are many obstructions, or in other
locations where signal strength is weak. Doing so may result in frequent
loss of connection, very slow communication speeds and errors.
Using close to an IEEE802.11g/b/n wireless LAN device may cause
mutual interference to occur, which may result in reduced communication
speeds or which may prevent connection. In this case, switch off the
power supply to the device that is not being used, or use the
thermometer in a different location.
If the thermometer does not connect normally when used near a wireless
station or broadcast station, use the thermometer in a different location.
A&D Company, Limited cannot accept liability for any damages incurred
due to impaired operation or data loss, etc. that occur through the use of
this device.
This device is not guaranteed to connect to all Bluetooth
devices.
connection in the range of a wireless LAN or
English 8
compatible