Pairing - A&D UT-201BLE-A Bedienungsanleitung Übersetzung

Using the Thermometer

Pairing

A Bluetooth device needs to be paired with a different specific device in
order to communicate with that device. If this thermometer is paired with a
receiver device from the start, measurement data is transmitted
automatically to the receiver device each time a measurement is made.
Cautions for Pairing
Only one device can be paired with this thermometer at one time. If the
receiver device cannot receive measurement data, try pairing again
If another receiver device is paired, the first device will be unpaired to
enable the new device to be paired.
Follow the steps below to pair the thermometer with a Bluetooth
compatible receiver device. Also refer to the manual of the receiver device.
Please use a pairing wizard if one is provided.
Pairing Procedure
1. Follow the instructions in the manual of the receiver
device to switch it to the pairable status. When pairing
this thermometer, place it as close as possible to the
receiver device to be paired with.
2. Install the battery as described on page 7.
Press the
Press the
The thermometer can be found by the receiver device
while " " is displayed for approx. one minute.
3. Find, select and build a pair with the receiver device in
accordance with its manual. When the pairing of the
receiver device is built, "
pairing is displayed.
4. If " " is displayed or pairing is failed, remove the
battery and try steps 1 to 3 again.
5. Follow the manual of the pairing receiver device to
search for, select and pair with this thermometer.
Communication Distance
The communication distance between this thermometer and the receiver
device is approximately 5 m.
This distance is reduced by the conditions in the surrounding environment,
so be sure to check that the distance is short enough for a connection to be
made after measurement is complete.
switch to turn the thermometer on.
switch while " " is displayed.
" of the decision of the
English 10