SUOMY Jumper Gebrauchsanleitungen Seite 31

If these conditions are not verified and removable cheek pads do not work properly, please refrain from using the
helmet and contact authorised Suomy staff.
INTERNAL CENTRAL PADDING
The comfort padding is attached to the internal cap by two press-studs at the back (Pic. 7) and by Velcro anchor
points positioned elsewhere (Pic. 8).
Removal
Insertion
After sticking the Velcro, ensure you have assembled the inner padding properly.
If these conditions were not verified and the internal padding was not properly assembled, please refrain from
using the helmet and contact authorised Suomy staff.
Insert the cheek pads (see paragraph Cheek Pads).
USE AND MAINTENANCE
The internal padding is attached to the helmet by two press-studs at the rear and by a
series of Velcro fastenings to the front
Remove the cheek pads (see paragraph Cheek Pads). Unlock the back press-studs (Pic. 7)
and release the Velcro by pulling the comfort padding towards the inside of the helmet (Pic. 8).
Then remove the internal padding.
Position the inner padding inside the helmet, by checking it is upright. First, clip the back
press-studs (Pic. 7) and then lay the padding against the internal profile of the helmet,
taking care to place them according to polystyrene shaping.
Place a slight pressure with the fingers, along the Velcro straps on the polystyrene to
ensure a proper fitting (Pic. 8).
EN