SUOMY Jumper Gebrauchsanleitungen Seite 30

EN
COMFORT PADDING
The JUMPER internal padding (central padding, right cheek and left cheek pads), can be easily removed to be
washed and/or replaced.
Internal Side Padding: Cheek Pads - removing and inserting.
The cheek pads are attached to the helmet's inside lining by three press-studs (Pic. 6 A).
INTERNAL SIDE PADDING: CHEEK PADS
The cheek pads are attached to the helmet's inside lining by three press-studs (Pic. 6 A).
Removal
Insertion
Check that the assembly is correct and that:
- The cheek pad is firmly locked in position
- The strap is completely free and has not been trapped under the cheek pad during assembly.
- The rapid system removal tab of the cheek pad is correctly positioned (Pic. 6 C).
The effectiveness of the fastening system depends on the correct locking of the cheek pad, and the correct
positioning of the strap.
USE AND MAINTENANCE
The removable cheek pad is fixed to the internal cap by three press-studs.
For removal, disengage the three press-studs by pulling gently towards the inside of the
helmet (Pic. 6 B).
To insert the cheek pads match the three press-studs (Pic. 6 A). Make sure of the correct
positioning of the removable cheek pad with a slight pressure, and then press the studs
closed.