Specifications - Sony Trinitron CPD-E250 Bedienungsanleitung

If thin lines appear on the screen
(damper wires)
These lines do not indicate a malfunction; they are a normal
effect of the Trinitron picture tube with this monitor. These are
shadows from the damper wires used to stabilize the aperture
grille. The aperture grille is the essential element that makes a
Trinitron picture tube unique by allowing more light to reach the
screen, resulting in a brighter, more detailed picture.
Self-diagnosis function
This monitor is equipped with a self-diagnosis function. If there is
a problem with your monitor or computer, the screen will go
blank and the 1 (power) indicator will either light up green or
flash orange. If the 1 (power) indicator is lit in orange, the
computer is in power saving mode. Try pressing any key on the
keyboard or moving the mouse.
x If the 1 (power) indicator is green
1
Disconnect the video input cable or turn off the
connected computer.
2
Press the 1 (power) button twice to turn the monitor
off and then on.
3
Move the joystick , for 2 seconds.
If all 4 color bars appear (white, red, green, blue), the monitor is
working properly. Reconnect the video input cables. Adjust the
brightness and contrast, and check the monitor. If the fault still
exists, check your computer.
If the color bars do not appear, there is a potential monitor failure.
Inform your authorized Sony dealer of the monitor's condition.
x If the 1 (power) indicator is flashing orange
Turn the monitor OFF and then ON.
If the 1 (power) indicator lights up green, the monitor is working
properly.
If the 1 (power) indicator is still flashing, there is a potential
monitor failure. Count the number of seconds between orange
flashes of the 1 (power) indicator and inform your authorized
Sony dealer of the monitor's condition. Be sure to note the model
name and serial number of your monitor. Also note the make and
model of your computer and graphics board.
* Recommended horizontal and vertical timing condition
• Horizontal sync width should be more than 1.0 µsec.
• Horizontal blanking width should be more than 3.0 µsec.
• Vertical blanking width should be more than 500 µsec.
** If the input signal is Generalized Timing Formula (GTF)
compliant, the GTF feature of the monitor will automatically
provide an optimal image for the screen.
Design and specifications are subject to change without notice.
8
Damper
wires

Specifications

CPD-E250
CRT 0.24 mm aperture grille pitch (center)
17 inches measured diagonally
90-degree deflection
FD Trinitron
Approx. 328 × 242 mm (w/h)
Viewable image size
(13 × 9
Viewing image 408 mm (16.1 inches)
Resolution
Maximum Horizontal: 1600 dots
Vertical: 1200 lines
Recommended Horizontal: 1024 dots
Vertical: 768 lines
Input Signal levels
Analog RGB: 0.7 Vp-p (positive), 75 Ω
Video Signal:
SYNC Signal: H/V separate or composite sync:
TTL 2.2k Ω Polarity free
Sync on Green: 0.3 Vp-p (negative)
Approx. 312 × 234 mm (w/h)
Standard image area
(12
Deflection frequency* Horizontal: 30 to 96 kHz
Vertical: 48 to 170 Hz
AC input voltage/current 100 – 240 V, 50 – 60 Hz,
Max. 1.7 A – 0.9 A
≤ 115 W
Power consumption
Operating temperature 10 ºC to 40 ºC
Approx. 402 × 418 × 421 mm (w/h/d)
Dimensions
(15
Mass (Monitor weight) Approx. 19 kg (41.9 lbs)
Plug and Play DDC2B/DDC2Bi,
GTF**
Supplied accessories Power cord (1)
Warranty card (1)
This instruction manual
CPD-E450
CRT 0.24 mm aperture grille pitch (center)
90-degree deflection
FD Trinitron
19 inches measured diagonally
Approx. 365 × 274 mm (w/h)
Viewable image size
(14
Viewing image 457 mm (18.01 inches)
Resolution
Maximum Horizontal: 1920 dots
Vertical: 1440 lines
Recommended Horizontal: 1280 dots
Vertical: 1024 lines
Input Signal levels
Analog RGB: 0.7 Vp-p (positive), 75 Ω
Video Signal:
SYNC Signal: H/V separate or composite sync:
TTL 2.2k Ω Polarity free
Sync on Green: 0.3 Vp-p (negative)
Approx. 352 × 264 mm (w/h)
Standard image area
(13
Deflection frequency* Horizontal: 30 to 96 kHz
Vertical: 48 to 170 Hz
AC input voltage/current 100 – 240 V, 50 – 60 Hz,
Max. 2.0 A – 1.1 A
≤ 130 W
Power consumption
1
Operating temperature
Approx. 451 × 471 × 461 mm (w/h/d)
Dimensions
(17
Mass (Monitor weight) Approx. 25.5 kg (56.1 lbs)
Plug and Play DDC2B/DDC2Bi,
GTF**
Supplied accessories Power cord (1)
Warranty card (1)
This instruction manual (1)
5
/ inches)
8
3 × 9 1
/ / inches)
8 4
7 1 5
× 16 × 16
/ / / inches)
8 2 8
3 × 10 7
/ / inches)
8 8
7 × 10 1
/ / inches)
8 2
0 ºC to 40 ºC
7 × 18 5 × 18 1
/ / / inches)
8 8
4