Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
I80
INSTALLATION (cont.)
Step 1 /
6
Feed the speaker cable through the
middle opening and line the mounting
bracket up horizontally or vertically,
using a spirit level. Now mark the
position of the screws in the slots with a
pencil (see Figs 4 + 5).
Step 2 /
6
a) Installation on a cavity wall:
continue with Step 3
b) Installation on a concrete wall:
Pre-drill holes for the rawlplugs at
the marked positions with:
Ø = 6 mm
L = 40 mm
- Insert rawlplugs (6 x 30)
Step 3 /
6
- Pull the speaker cable through the
middle opening
- Screw the mounting bracket firmly
into position using washers and
stainless steel screws (4 x 40 mm)
Torx TX20.
Step 4 /
6
Guide the speaker into the bracket,
as shown in Figure 6 and fix it in
place, by turning the two rotary
knobs on both sides.
6
Swiss Sound Solutions
Figure 4
Figure 5
Figure 6
Werbung
Kapitel
Inhaltsverzeichnis
