Troubleshooting - Panasonic CF-VDM302AT Bedienungsanleitung

Troubleshooting

The computer does not recognize
the drive
The Multimedia pocket device
status indicator
Cannot play disc or read data
from it
Cannot eject disc
The disc tray does not close
Other disc operation problems
1
Check the settings by following the instructions in
"Preparations" (
Is the drive properly mounted in the multimedia
pocket?
Restart the computer.
Is the disc loaded on the tray correctly?
(
does not light
Is the disc bent, scratched, or dirty?
An error may occur if, after the tray has been closed
or operation has been resumed from the sleep*
bernate modes, the drive is accessed before the Mul-
timedia Pocket device status indicator
Also, an error may occur if the drive is accessed by
the application software automatically. In a case like
this, remove the disc, re-insert it, and try again.
1
*
Turn on the computer.
To remove a disc when the
computer is powered off, insert a
pointed object (e.g., the bent-out
tip of a paper clip) into the
emergency hole (A). Pushing it completely to
the end will free the tray so that it can be pulled
out. (The position of the emergency hole differs
depending on the drive.)
If a disc with fingerprints or other dirt is used, you
may not be able to remove it. Use a clean disc.
(
Do not touch the eject button when closing the tray.
Use another drive or media.
page 9).
page 9)
standby
Windows XP
page 8)
1
/ hi-
goes off.