Before Using The Product For The First Time; Setting Mode - Samsung DW60H9970 Serie Bedienungsanleitung

Before using the product for
the fi rst time

SETTING MODE

Turn on the dishwasher, and hold down both the Sanitize and Delay Start buttons for 3 seconds to enter
Settings mode.
Pressing the Sanitize button changes the mode in this sequence:
Sound settings mode  Brightness mode (for some models)  Water refl ector mode 
Water softener mode (for some models)  Auto Door mode (for some models).
Sound settings mode
Press the Sanitize button until "U1" or "U0" is displayed. To change the setting, press the Delay Start
button. "U0" means that the sound is off for all cycles.
This setting is continue before changing again.
Water softener mode (Water hardness level setting)
1. Press the Sanitize button to enter Water softener mode ("L3" on the display indicates Water softener
mode).
2. Once you enter the setting for the water hardness, the current hardness level setting is displayed.
3. Use the Delay Start button to select the water hardness level from Level 0 to Level 5.
(Refer to the table below for the water hardness level setting in your area.)
If the water hardness level in your area is very low, you do not need to use dishwasher salt.
However, you need to set the water hardness setting for the dishwasher to 0.
4. To exit the water hardness setting, press the Power
Water hardness level chart
The water hardness is measured using German degrees (°dH), French degrees (°TH), or mmol/ℓ
(International unit for the water hardness).
Level
ºdH
0 <6
1 6~14
2 14~23
3 23~31
4 31~40
5 >40
User Manual_DW9000H-FS_00158C-03_EN.indd 21 User Manual_DW9000H-FS_00158C-03_EN.indd 21
Water hardness
ºTH mmol/ℓ Range
No
<10 <1.0
recycle
10~25 1~2.5 1/8
25~40 2.5~4.0 1/5
40~55 4.0~5.5 1/3
55~70 5.5~7.0 1/2
>70 >7.0 1/1
English - 21
button.
Regeneration softening/
washing cycle (ECO program)
No
Yes
Yes
Yes
Yes
Yes
Salt
injection
No
Yes
Yes
Yes
Yes
Yes
2015-03-24 2015-03-24 5:30:17 5:30:17