Electrical And Pneumatic Connections - TECO 40 TOP Bedienungsanleitung

1.2.d. ELECTRICAL AND PNEUMATIC CONNECTIONS
A good earth connection is essential for correct operation of the machine.
The electric connection used must be suitably sized:
• to the electric power absorbed by the
machine, indicated on its data plate (Fig. 1);
• to the distance between the operating
machine and the power supply connection
point, to ensure that the voltage drop under
full load does not exceed 4% (10% during
start-up) of the rated voltage value specified
on the plate
- The user must:
• fit a power plug in compliance with current
regulations on the power supply lead;
• connect the machine to its own electrical connec-
tion - A, Fig. 2 - equipped with a differential automatic
circuit breaker with 30mA sensitivity;
• install protection fuses on the power line that are
suitably sized in accordance with the indications
provided on the machine data plate (Fig.1);
• connect the machine to an industrial socket; the
machine must not be connected to domestic sockets.
Make sure that the available pressure and perform-
ance of the compressed air system are compatible
with what is necessary for correct machine operation
- see the section "Technical data". For the correct
operation of the machine, the pneumatic supply line
must provide a pressure range from a minimum of
8 bar to a maximum of 16 bar.
For correct equipment operation, the air produced must be suitably treated (not
above 5/4/4 according to standard ISO 8573-1).
User's manual
WARNING
Mod.
V
A
kW
Hz
Ph
bar/psi
WARNING
ANNO DI COSTRUZIONE /
Code
MANUFACTURED
X-XXXXXXXX/XX - XX
Serial N.
XXXXXXXXX
B
EN
1
A
2
83