Lifting/Handling; Installation Area - TECO 40 TOP Bedienungsanleitung

5. LIFTING/HANDLING

In order to remove the machine from the pallet,
hook it as shown in figure 7.
This lifting point must be used whenever you
need to change the position of the machine. Do
not attempt to move the machine until it has been
disconnected from the power and pneumatic
supply networks.

5.1 INSTALLATION AREA

Install the machine in compliance with all the applicable safety standards, in-
cluding, but not limited to, those issued by OSHA.
IMPORTANT: for the correct and safe operation of the equipment, the ambient lighting
level should be at least 300 lux.
IMPORTANT: Do not install the machine outdoors. It is designed to be used in closed,
covered areas.
RISK OF EXPLOSION OR FIRE. Do not use the machine in areas that could be
exposed to inflammable vapours (petrol, paint solvents, etc.).
Do not install the machine in a narrow area or position it below floor level.
90
WARNING
CAUTION
CAUTION
DANGER
7
User's manual