Before Use; How To Use; Attaching The Stabilisers; Operating The Hinge System - Powerfix Profi HG01091 Montage-, Bedienungs- Und Sicherheitshinweise

Correct inclination.
65°-75°
Secure top / bottom ladder ends.
Always keep hinges clean and oiled.
Do not use ladder without stabilisers.
Do not stand on one of the upper
3 rungs of a leaning ladder!
Do not stand on one of the upper
2 rungs of a standing ladder.
Warning! Do not insert your fingers
into the holes in the ladder frame.
Do not stand on the top rung!
Ensure that the top end of the ladder
is properly supported!

Before use

Q
J
A void damage when transporting ladders on
roof racks or in a lorry. Make sure that the
ladder is appropriately fastened in place.
1
J
B efore using the ladder
Check that all parts are undamaged and in
good working order. Do not use a damaged
ladder.
J
R emove all contamination on the ladder
such as wet paint, dirt, oil or snow.
J
L ock all doors and windows (but not emergency
exits) in the area around the ladder
you are going to work.
J
Verify the ladder is suitable for the respective
use.
Safety instructions / Before use / How to use
, visually inspect it.
1
,
1
where
1

How to use

Q
CAUTION! RISK OF CRUSHING! Take
particular care when opening or closing the
ladder . Keep your distance from moving
1
parts and the safety devices.

Attaching the stabilisers

Q
ATTENTION! Never use the ladder
out the stabilisers attached
J
U se the supplied stabilisers
J
I nsert the stabilisers
ends of the ladder
1
holes in the stabiliser and the ladder end
8
align with one another.
J
G uide four bolts
3
and secure the connection with one plain
8
washers and nut on each bolt
4
ATTENTION! Check every time before load-
ing the ladder that the stabilisers
1
rectly attached.

Operating the hinge system

Q
J
B efore each use, check that all the hinges
are properly engaged. The hinges
parallel to one another must always be engaged
at the same setting.
J
U nlock the hinges
10
lever backwards (see Fig. E).
11
J
A rticulate the desired section of the ladder at the
hinges . The hinges engage automatically in
10
the next position. Unlock the hinges
if you would like to articulate the ladder further.
ATTENTION! The hinges
audible click. However, you should always check
that the safety indicator
(see Fig. G). Do not load the ladder if the safety
indicator shows "unlocked" (see Fig. F).
12
with-
1
.
2
only.
2
into the slots at the
2 9
(see Fig. D). Ensure that the
(included) through the holes
(see Fig. D).
5
are cor-
2
10
lying
10
by pulling the unlocking
again
10
engage with an
10
shows "engaged"
12
GB/CY 9