How To Use; Attaching The Stabilisers; Operating The Hinge System - Powerfix Profi HG01091 Montage-, Bedienungs- Und Sicherheitshinweise

- check that the hinges between front
and rear sections are not damaged,
loose or corroded;
- check that the locking stays horizon-
tal, back rails and corner braces are
not missing, bent, loose, corroded
or damaged;
- check that the stabilizer bars are
fixed and in a good condition.
- check that rubber feet / end caps
are not missing, loose, excessively
worn, corroded or damaged;
- check that the entire ladder is free
from contaminants (e.g. dirt, mud,
paint, oil or grease);
- check that locking catches (if fitted)
are not damaged or corroded and
function correctly;
- check that the working platform (if
fitted) has no missing parts or fixings
and is not damaged or corroded. If
any of the above checks cannot be
fully satisfied, you should NOT use
the ladder.

How to use

CAUTION! RISK OF CRUSHING!
Take particular care when opening
or closing the ladder
distance from moving parts and the
safety devices.

Attaching the stabilisers

ATTENTION! Never use the ladder
without the stabilisers attached
1
. Keep your
1
.
2
U se the supplied stabilisers
I nsert the stabilisers
at the ends of the ladder
Ensure that the holes
liser and the ladder end align with
one another.
G uide four bolts
the holes and secure the connec-
8
tion with one plain washers
nut on each bolt
ATTENTION! Check every time be-
fore loading the ladder
stabilisers are correctly attached.
2

Operating the hinge system

B efore each use, check that all the
hinges are properly engaged. The
10
hinges lying parallel to one an-
10
other must always be engaged at
the same setting.
U nlock the hinges
unlocking lever
Fig. E).
A rticulate the desired section of the
ladder at the hinges
engage automatically in the next po-
sition. Unlock the hinges
you would like to articulate the ladder
further.
ATTENTION! The hinges
with an audible click. However, you
should always check that the safety
indicator shows "engaged" (see
12
Fig. G). Do not load the ladder if the
safety indicator
(see Fig. F).
only.
2
into the slots
2
(see Fig. D).
1
in the stabi-
8
(included) through
3
and
4
(see Fig. D).
5
that the
1
by pulling the
10
backwards (see
11
. The hinges
10
again if
10
engage
10
shows "unlocked"
12
GB 11
9