Mode Selector Switch Functions; Jumper Functions - Renkforce AC-239 Bedienungsanleitung

8. Mode Selector Switch Functions

The mode selection switch is at the front of the alarm system.
Use the mode selection switch to determine the three different operating modes.
OFF
OFF:
HOME AWAY
OFF
HOME: The alarm system is switched on and the exit delay starts
HOME AWAY
OFF
AWAY: The alarm system is switched on and the exit delay starts
HOME AWAY
During the exit delay, the status LED "EXIT" flashes quickly. After the end of the exit
delay, there is a short signal sound (depending on the position of jumper B). When
the alarm system is armed, the status LED "EXIT" flashes slowly.

9. Jumper Functions

The jumpers are on the PCB to the right of the connection terminal.
Jumper 1 (internal signalling device)
1 2
ACTIVATED
A
1 2
DEACTIVATED In case of an alarm, no acoustic alarm is triggered
A
The complete alarm system is switched off. The door bell
function is exempted from this.
(duration = 60 seconds). After the end of the exit delay, only
alarm zone 1 is armed.
(duration = 60 seconds). After the end of the exit delay, both
alarm zones are armed.
In case of an alarm, an acoustic alarm is triggered
by the internal signalling device.
by the internal signalling device. This does not app-
ly to the internal door bell and the signal sounds.
33