Avoiding Radio Interference; Assembling The Accessories; Metal Rack - Caso 3346 Bedienungsanleitung

• The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 20 cm above the oven, 10 cm around the back and 5 cm on both sides.
• Do not cover up any openings on the device and do not block these off.
• Do not remove the device's adjustable feet.
• The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
• The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they guarantee
the prerequisites for the safe use of this device.
10.5.2

Avoiding radio interference

The device can cause the occurrence of interference in radios, televisions or similar devices.
Such faults can be rectified or reduced as a result of employing the following measures:
• Clean the door and the sealing surfaces of the device.
• Set the radio, the television, etc as far as possible away from the device.
• Connect the device to a different electrical outlet, so that various power circuits are used
for the device and the receiver with the interference.
• Use a properly installed antenna for the receiver, to ensure good reception.

10.6 Assembling the accessories

10.6.1

Metal rack

•
Place the metal rack into the device with the round spacer facing the direction of the
inner rear wall. Check that the metal rack is placed correctly.
caso IMG23/IMG25
Attention
► The rubber stoppers may not be removed
from the metal rack.
► Only place the metal rack in the direction
displayed in the diagram.
49