testo 926 Bedienungsanleitung Seite 30

5. Operation
30
On was selected:
Use
2
threshold ( ) and confirm with
Use
3
threshold ( ) and confirm with
3
To r r egister t t he r r adio p p robe:
Radio modules / radio probes may only be used in
countries in which they have been Type Approved
(see application information of the radio module / radio
probe).
The setting function for radio probes is only available if
a radio module (accessory part) is inserted into the
measuring instrument.
See the chapter
If no radio module is inserted:
Continue with objective
Each radio probe has a probe ID (RF ID). This consists of
the last 3 digits of the serial no. and the position of the
slide switch in the radio probe (H or L).
Configuration mode is opened and RF ID and Auto are
lit.
The radio probe is switched on and the transfer rate is
set to 2 readings per second (see application infor-
mation of the radio probe).
Select the desired option with
1
:
· YES: Switches automatic probe detection on
(recommended).
· no: Switches automatic probe detection off.
no was selected:
Use
2
confirm with
YES was selected:
- Automatic probe detection is started. Auto flashes
while the instrument looks for a radio probe that is
switched on.
/ to set the value for the upper alarm
/ to set the value for the lower alarm
C
OMMISSIONING
/ to set the probe ID manually and
.
.
.
110/925/926>
.
T A O
O SET UTO FF
and confirm with
.