AIPTEK PocketCam 5800 Gebrauchsanweisung Seite 23

Troubleshooting - 
When using the camera:
Problem
I did not delete the pictures
and video clips, but can
not find them in playback
mode.
The camera does not
respond to any action
during operation.
The recorded pictures
appear too blurred.
The recorded pictures or
video clips appear too
dark.
Noises occur when viewing
images on the LCD screen
or on the computer.
The settings are changed
after I replace batteries.
Cause
The camera is using a card:
The lost recordings are saved
in the internal memory.
The camera is using SDRAM:
The lost recording is replaced
by the new one, or is gone
because of power outage.
The camera encounters
software failure.
The focus is not correctly set.
The environment of shooting
or recording does not have
adequate light.
The flicker setting does not
match the standard of the area
you are staying.
The camera is not equipped
with an internal battery or flash
memory to save the settings.

Solution
It happens when you insert
a memory card after taking a
few pictures or videos. You
can access those files after
removing the memory card.
The camera using SDRAM can
only save one recording and
needs battery power to retain
the file. Please use a memory
card instead.
Remove the batteries
and replace them into the
compartment. Then power on
the camera.
Adjust the focus to an
appropriate position.
Use flash strobe when taking
pictures. Add extra light
sources when recording video
clips.
Adjust the flicker setting. Refer
to the "Flicker Table" on
page 11.
Reset the settings.