Checking The Fuel Tank Level; Operation; Information On Initial Start-Up; Grounding - Zipper Maschinen ZI-STE2800 Betriebsanleitung

13.3.2 Checking the fuel tank level

1. Screw on the tank cap (sits on the fuel tank).
2. Level check in the form of a visual inspection or via display. If necessary, top
3. Close the fuel filler cap tightly after refuelling.
14

OPERATION

14.1.1 Grounding

Before putting the machine into operation, have a grounding system installed by a qualified
electrician!
Exact grounding instructions for portable generators depend on the jurisdiction of the country in
which the generator is commissioned. Please observe them exactly.

14.1.2 Test Run Initial Start-up

 Let the machine run idle for about 3 minutes.
 Pay attention to abnormal noises.
 Pay attention to the exhaust fumes (too black, too white)?

14.1.3 Notes on the first 20 operating hours

In order to optimize the life expectancy of your machine, the following points should be observed:
 Do not operate the engine for the first 20 operating hours @ maximum load (this also
applies to used engines after extensive maintenance). This means lower speed and lower
maximum working load than during normal operation.
 Change the engine oil after the first 20 hours of operation.

14.2.1 Integration into an existing electricity grid

This machine is designed exclusively for the operation of electrical devices whose maximum
power lies within the power specifications of the generator. A higher starting current from
inductive loads must be taken into account. The generator is designed for the operation of
conventional ohmic and inductive loads such as light chains, electric hand tools (drilling machines,
electric chain saws, compressors).
When connecting to stationary systems such as heating, house supply, air conditioning or for the
power supply of mobile homes, an electrician and the heating manufacturer must be consulted
regarding connection and grounding.
ZIPPER MASCHINEN GmbH
ZI-STE2800; ZI-STE5500; ZI-STE800; ZI-STE8004
Observe the safety regulations for fuel control. Filter the fuel during refuelling to
prevent foreign particles from entering the combustion chamber. Wipe up leaked fuel.
up with fuel with the appropriate octane number (RON 95).

Information on Initial Start-up

Note that the machine is delivered without engine oil and fuel. Make sure that
this equipment is filled up before the machine is put into operation for the first time.
ATTENTION: The machine does not start until the engine oil has been refilled to
the upper limit.

Operating Instructions

www.Zipper-Maschinen.at
N O T I C E
N O T I C E
OPERATION
37