Checklist Before Each Use; Checking The Engine Oil Level - Zipper Maschinen ZI-STE2800 Betriebsanleitung

8. Battery assembly
Loosen the protective cover to get access to the battery.
- Mount the poles to the battery with screws, washers and nuts.
- Connect the red cable to the positive (+) terminal of the battery.
- The black cable is connected to the negative pole (-) of the battery.
- Disconnect and connect the battery in reverse order.

13.3.1 Checking the engine oil level

ZIPPER MASCHINEN GmbH
ZI-STE2800; ZI-STE5500; ZI-STE800; ZI-STE8004

Checklist before each use

Too low an oil level will damage the engine and shorten the life of the machine.
Therefore, check the engine oil level before every start and top up the engine oil if
necessary.
www.Zipper-Maschinen.at
N O T I C E
1. To check the engine oil level, place the
machine on a safe, level surface. Switch
off the engine and allow the machine to
stand for ten minutes so that the
circulating oil can collect in the oil pan.
2. Unscrew the oil dipstick and wipe with a
clean, lint-free cloth or a non-fibrous
paper towel.
3. Push the dipstick into the opening, but
do not screw it in. (Make sure that the
dipstick has really been pushed in
completely).
4. Pull out the oil dipstick again and read
off the oil level. There are two markings
for this - see illustration on the left.
5. If the oil level is low, refill the
recommended oil up to the upper edge
6. Push in the oil dipstick again and
tighten.
ASSEMBLY
36