Check The Fuel Level; Check The Air Filter; Grounding; First Use - Zipper Maschinen ZI-STE6700DH Betriebsanleitung

13.1.2

Check the fuel level








13.1.3 Check the air filter

Check the core of the air filter, ensuring that it is clean and performs well.
 Loosen the screw on the cover of the air filter, and then dismantle the cover to check the
filter.
 Please clean or change the filter if necessary.



13.1.4 Grounding

Before starting up the machine, have it grounded by a qualified electrician! If the machine
is intended for mobile operation, get a grounding cable with sufficient cross section from
your electrical retailer.

13.2 First use

Make sure to treat the machine with care, when using it for the first time. After starting, let the
motor run for 5 minutes without connecting the generator with consumer load.
Following points should be checked in the first 5 minutes:
 Is the sound of the generator normal?
 Are the vibrations not to strong?
 Exhaust gases should not look black or white.
 Is oil pilot light showing?
If these points meet the demands, the generator can be used further. Otherwise stop the generator
and find the cause of the problem.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-STE6700DH & ZI-STE7500DSH
Only use fuel according to specification EN 590 ("normal" Diesel fuel).
Make sure that no other particles (filth, dust, water,...) enter the tank and
never remove the filter.
Only refuel with an equipped filter.
After filling up the tank, fix the tank cap again.
Turn off the machine and wait unit it cooled down before filling up the tank.
Open light, fire, sparks, smoking in a surrounding area of 10m are not
allowed.
Do not run the engine without the air filter, or else filth will enter the engine
through carburetor, resulting in quick wear and tear of the engine.
If the power output drops or the colour of the exhaust gases does not lock normal,
renew the air filter immediately.
N O T I C E
W A R N I N G
N O T I C E
OPERATION
20