Troubleshooting; Digital-Display - Zipper Maschinen ZI-STE2800 Betriebsanleitung

17

TROUBLESHOOTING

Hot surfaces and rotating machine parts while the engine is running can cause
serious injury or even death. Always stop the machine before carrying out
troubleshooting work and secure it against unintentional restarting.
Trouble
The engine
doesn't start
Engine is difficult
to start or runs
bad
Motor is too hot
Motor too little
power
No power from
the power
outlets
Low output
voltage under
load
Uneven Output
voltage
Digital display
"P-25"
Digital display
"P-50"
Digital display
"P-100"
ZIPPER MASCHINEN GmbH
ZI-STE2800; ZI-STE5500; ZI-STE800; ZI-STE8004
 No fuel
 Turn engine switch to ON
 Reversing defective
 Check oil level
 Spark plugs contact Candle
 Air filter clogged
 Fuel tap clogged
 Faulty motor
 Too rich fuel mixture
 Carburetor incorrectly
 Faulty spark plug, dirty or
misaligned
 Too little engine oil
 Cold air system restricted
 Dirty air filter
 Carburetor not adjusted properly
 Dirty air filter
 Breaker is in position "OFF"
 Engine speed is too low
 Too much load available
 Unbalanced load available
 P-25: Request to first oil change
when a new device after 25
operating hours
 P-50: Request to Change oil and
clean the air filter every 50
operating hours
 P-100: Request for cleaning the fuel
and air filter and oil change every
100 operating hours
www.Zipper-Maschinen.at
W A R N I N G
Reason
TROUBLESHOOTING
Shooting
 Filling the fuel tank
 switch to ON
 repair recoil
 add oil
 OIL LEVEL CONTROL!
 Check for real game 16.2.3
 See Maintenance 16.2.2
 refer to Maintenance
 refer to Maintenance
 Contact the retailer
 Set choke to OPEN position
 Can make settings by
authorized personnel
 Clean the spark plug, New
Adjust or replace
 Engine oil
 Clean fan guard, internal
 Clean the cooling fins
 Clean the air filter
 Let carburetor adjusted by
authorized specialist
 Clean the filter elements,
possibly exchange
 Breaker to position "ON"
 Let engine speed of an
authorized service set
 Reduce Existing Load
 Total load away. Then apply
again individually to determine
what causes the uneven loads
the function.
 Change Engine Oil
 Change the engine oil
 Clean the air filter
 Clean the fuel filter
 Clean the air filter
 Change the engine oil.
44