Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connection scheme
Warnings
- Installing a car hi-fi system requires important professional skills and experience, which are not covered in this manual. If needed, consult a
technician to avoid damaging your system or the vehicle. Proper installation is essential for the system's reliable operation.
- The warranty is not applicable to damage caused by improper installation or connection.
- Make sure to connect the capacitor with the correct polarity. Otherwise the device might explode. Only connect a previously charged
capacitor into the system.
- You must not connect a fully discharged capacitor without control electronics to the car battery: the sudden high current during charging can
damage the battery and cause injury.
- You must not short-circuit the capacitor's poles while connecting it (e.g., through unintentionally touching both poles with a tool).
- You need to use a cable with sufficient diameter to meet the power consumption of your amplifier.
- Before starting to use the capacitor, make sure the output screws are fastened.
- Never cover the device and only install it in a location with proper ventilation.
- Protect from sunlight, humidity, water and shocks.
- Do not expose the device to extreme temperatures.
- Clean with a soft, dry cloth.
Technical parameters
capacitance:...............................................................................1.0 farad
tolerance: ........................................................................................ 20 %
max voltage: ............................................................................... 20 V DC
max temperature: ............................................................................95 C
internal resistance................................................................ 0.0015 Ohm
voltmeter display: ....................................................................3 digit LED
voltmeter range: .................................................................... 7.2 – 19.8 V
operating current:...........................................................................50 mA
standby current: ...............................................................................2 mA
dimensions:..........................................................................76 x 260 mm
accessories: a pair of fasteners, screws, connectors, mounting tool, resistor for
charging/discharging
G
B
C
A
R
S
T
E
R
E
O
-
+
P
O
W
E
R
S
U
P
P
0
S
A
0
3
0
L
Y
C
A
P
A
C
I
T
O
R
+
-
Werbung
